Hello,
Many thanks for your answers, Francois.
I'd like to know whether the ground state calculation is finished with a full SCF convergence.
I found that "etotal" comes 30 times in the output file for run 0 30 10 , but it is not clear how accurately it was converged.
Would you let me know how we can know whether the SCF calculation reached the convergence criterion or how accurately it was reached?
Even though it is not fully converged, may I use the final xml file obtained from 30 SCF gs calculation for MD simulation?
Otherwise, will it be better that I increase nitscf in the "run command" from 0 30 10 to 0 300 10?
In addition, in my simulation, wf_dyn JD is used for gs calculation while wf_dyn PSDA is used for MD calculation. Will it be all right?
Best regards,
Young
the convergence of ground state calculation
Forum rules
You must be a registered user to post in this forum. Registered users may also post new topics if they consider that their subject does not correspond to any topic already present on the forum.
You must be a registered user to post in this forum. Registered users may also post new topics if they consider that their subject does not correspond to any topic already present on the forum.

 Site Admin
 Posts: 164
 Joined: Tue Jun 17, 2008 7:03 pm
Re: the convergence of ground state calculation
Hello Young,
When running the
Note that the variable the
If the convergence is not satifactory with 30 SCF steps, you can of course use the saved restart file to continue the ground state calculation with additional SCF iterations.
The choice of the
Best regards,
Francois
When running the
run 0 30 10
command, you can check the convergence of the ground state by checking the value of the <etotal_int>
in the output file. This value is the KohnSham energy at the end of each SCF iteraion. You can decide if the calculation is converged by looking at the differences between successive values of <etotal_int>
. If you are computing the ground state to start an MD simulation, a change in energy of 1.e6 (1 microHartree for the entire system) is usually sufficient. If you are looking at computing accurate ionic forces (e.g. when computing vibrational frequencies) you may want to get a change of < 1.e8 Hartree. Note that the variable
scf_tol
can be used to reach a given accuracy. For example, if you useCode: Select all
set scf_tol 1.e6
run 0 30 10
run
command will repeat SCF iterations until a convergence of 1.e6 Hartree is reached, but not more than 30 SCF iterations.If the convergence is not satifactory with 30 SCF steps, you can of course use the saved restart file to continue the ground state calculation with additional SCF iterations.
The choice of the
wf_dyn
variable (JD or PSDA) depends on what you know about the system. JD is the safest (most stable) since it performs a Jacobi Davidson iteration. However it can be expensive. If you are confident that the HOMOLUMO gap will be finite during the simulation (e.g. as is the case in water simulations) you may used PSDA (preconditioned steepest descent with Anderson acceleration) which may be faster. The PSDA algorithm can become unstable if the HOMOLUMO gap closes.Best regards,
Francois